Chevrolet Malibu Forums banner
Status
Not open for further replies.

OnStar controls for aftermarket radio??

8K views 10 replies 4 participants last post by  Casper_ 
#1 ·
#3 ·
So the navigation will show on the screen?
 
#4 ·
Very doubtful, but the voice prompts should remain:

Retains OnStar® system functionality when the factory radio is replaced in an 11-bit GMLAN vehicle. Generates all safety warning chimes and audible turn signal indicators.
 
#5 ·
Ah ok. I see. Thank you sir!
 
#6 ·
Yep that's exactly what you need. I have my metra harness combined with an ASWC module so I have factory steering wheel controls on my Pioneer navi.

I use the GMOS-LAN-04 - it costs around 100$ on amazon/sonicelectronix.

The ASWC is around 45 on amazon for steering wheel controls and the antenna adapter - the 40-CR10 from metra or CRAB from scosche is around $5

combine all that and the dash kit for a double din : the 95-3302 from metra and you're all set.

Let me know if you need any help.. Great choice with the pioneer by the way :D

EDIT: programming the steering wheel controls was not fun on these cars because you have to hold the volume up button, which kicks on onstar and turns off the radio, so I ran a constant 12v to the ASWc and radios 12v switch until i programmed it and then rmeoved the 12v constant after
 
#7 ·
Thanks I will let you know when I need help lol.
And does the navigation pop up on screen?
 
#9 ·
Is that for it to pop up on the aftermarket unit?
 
#11 ·
Aw ok. Thanks
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top