Chevrolet Malibu Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Gen 7 Problems/Service Issues/Troubleshooting
    Hello all I have a 2012 chevy malibu. Got an alignment 2 days ago and now when I’m driving the wheel will suddenly jerk to the right then after a second it will jerk back to center. This happened a little bit before but only when shifting around 40mph and I just acquitted it to torque steer...
  2. Gen 5 & 6 Wheels, Tires & Suspension
    Hello all, I brought my car in for an alignment (slight drift, just replace rear shocks, front struts, power steering torque sensor) and was told they cannot do the alignment due to the power steering rack being loose internally and that I need a left front tie rod and to replace the rack and...
  3. Gen 5 & 6 Wheels, Tires & Suspension
    I have a 2004 malibu that I just replaced all front end suspension parts on (control arm, inner and outer tie rod ends and sway bar links). I noticed that the rear of the vehicle was sitting extremely low so I purchased coil springs for the rear as well. The driver side tire on the rear also has...
  4. Gen 7 Do It Yourself Maintenance
    This is my 1st attempt at rear adjustment on my 2012, I've read camber bolts to be used, or SPC Alignment shim part number 75400 and spacer kit 75970. I have only seen 1 bolt on the lower that can or has been adjusted after the last alignment. Attached is a copy of the last alignment, lost a...
  5. Gen 7 Wheels, Tires & Suspension
    my inside front left tire has worn down to the metals fibers the inside edge small section about an inch or so can i adjust the camber or do i have to buy a camber bolt
1-5 of 5 Results
Top