Chevrolet Malibu Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Gen 5 & 6 Problems/Service Issues/Troubleshooting
    Replaced starter and checked battery post and cable going to the solenoid and still won't crank ran wire from positive battery post to solenoid the starter is operating properly but it's still will not turned over checked tried starting in neutral still will not start when I try to turn the key...
  2. Gen 7 Problems/Service Issues/Troubleshooting
    I'm going to try and put as much information in here as possible so sorry if this ends up being a lengthy post! About three and a half weeks ago I began having an intermittent no crank no start issue. It started when I turned the vehicle off after driving about an hour and a half. It took me a...
  3. Gen 7 How-To/Write-Ups
    For a week I couldn’t start my Chevy malibu, until I replaced both the intake and exhaust vvt solenoids, that’s when I noticed that the intake exhaust solenoid’s connector wire was broken. Autozone wouldn’t have had another connector in stock for 2 weeks, so I tried to drive it for short...
  4. Gen 5 & 6 Problems/Service Issues/Troubleshooting
    I have a no crank no start condition on my 2007 Malibu. -new touchscreen radio installed. -started fine for a week after install. -condition occurred day after car wash but did still start multiple times that night and next day after washing it in the touch less car wash with underbody wash...
  5. Gen 8 Problems/Service Issues/Troubleshooting
    it is not possible to read codes from scanner i have tested ecu outside car with a company and it is good. i tried reading fuses with test light/multimeter results: green ones ok , red ones does not show light in neither of both pins (even with switch on). with the multimeter the red ones shows...
  6. Gen 7 Problems/Service Issues/Troubleshooting
    I have a 2010 Chevy Malibu LS with around 112,000 miles on it. Ever since I bought it last March I've been having electrical issues with it. Randomly upon starting the gauges would go haywire. The needles jumping up and down constantly, and all the warning lights would come on and error...
1-6 of 6 Results
Top