Chevrolet Malibu Forums banner
no start

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Gen 5 & 6 Problems/Service Issues/Troubleshooting
    I have a no crank no start condition on my 2007 Malibu. -new touchscreen radio installed. -started fine for a week after install. -condition occurred day after car wash but did still start multiple times that night and next day after washing it in the touch less car wash with underbody wash...
  2. Gen 7 Problems/Service Issues/Troubleshooting
    I have a 2011 Malibu no I’m driving to work I was losing power and stalling, when I went to leave work it would not start but it’s turning over. The only code I’m getting is P0108 for the intake manifold pressure sensor, I replaced the sensor and it still will not start. I see no wire damage or...
  3. Gen 8 Problems/Service Issues/Troubleshooting
    it is not possible to read codes from scanner i have tested ecu outside car with a company and it is good. i tried reading fuses with test light/multimeter results: green ones ok , red ones does not show light in neither of both pins (even with switch on). with the multimeter the red ones shows...
  4. Gen 7 Problems/Service Issues/Troubleshooting
    My 2012 Malibu will intermittently crank but not start. No codes are being thrown and if it sits for about 45 minutes it will usually start. I replaced the fuel pump and the relay in the trunk but still having the same issue.
  5. Gen 8 Problems/Service Issues/Troubleshooting
    Last night I was driving and all of a sudden the car stalled on me. I was not able to get it going again and had to push it home. After I got home I tried but it wouldn't start again. The car does crank over like it wants to start and intermittently it gets a little bump of power like it almost...
  6. Gen 7 Problems/Service Issues/Troubleshooting
    I have a 2010 Chevy Malibu LS with around 112,000 miles on it. Ever since I bought it last March I've been having electrical issues with it. Randomly upon starting the gauges would go haywire. The needles jumping up and down constantly, and all the warning lights would come on and error...
1-6 of 6 Results