Chevrolet Malibu Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
There's three bell housing bolts that on the top side of the transmission, I believe they were 15mm bolts, and one of those bolts should have a nut attached to it, it is the top side mounting bolt that is nearest to the front of the car. I brought that negative cable to that bolt and it is clear that the procedure is to take the nut off of the mounting bolt, slip the negative cable onto the bolt, then screw the nut back into place. If you bring the negative cable towards the transmission it would be the only mounting bolt that it could reach. I can try to take a picture tomorrow
Mine negative cable appears to already be attached I tried looking for anything else that was disconnected but couldn’t find anything my car is doing the exact same thing your car was doing with the error and power streering
 
1 - 3 of 3 Posts
Top