Chevrolet Malibu Forums banner
1 - 1 of 6 Posts

· Administrator
2011 Malibu LTZ 3.6L V6 Red Jewel Tintcoat
21,134 Posts
To gain access to the back of the vents, first try removing the center dashboard upper glove box. To access the screws, remove the 2 little rubber bumpers nearest the latch. Remove them, then lift from the side with the latch and continue rotating until the back part clears the dash. You'll understand better once you do it.

If that isn't enough access, then you're gonna learn how much Lego mentality went into this car:
  1. set the parking brake
  2. turn key to ON but don't start engine
  3. move shifter to N or D
  4. turn key to ACC
  5. at the back of the shifter bezel where it meets the console, lift to unsnap it, then push down on the front to clear the tabs from the center stack trim
  6. unscrew the bottom of the center stack trim and carefully unsnap it
Continue with the same Lego mentality until you get where you need to go.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.