Year, model, engine, transmission please.
Car won't start unplug fuel pump relay then it starts
I had code p0013 so I replaced the camshaft position selanoid also replaced the fuel pump. The car will turn over but won't start so I pulled the fuel pump relay in the trunk and plugged it back in and the car starts. I'm not getting any codes. Any ideas on what to do would be greatly appreciated!
1 - 5 of 5 Posts
2010 chevy malibu 2.4l 6 speed trannyYear, model, engine, transmission please.
That fuse box in the trunk has seen it's share of problems. I would carefully disassemble the box looking for corrosion and chaffed wires. Switch the fuel pump relay with the horn relay if possible. Disconnect the battery before doing any of this work. Best case scenario would be to find and obvious poor connection. Where the wires leaving this box enter the interior of the car has been a trouble spot for damaged wires.
We did put a different fuse box in the trunk but we will check the wires were they go inside of the car for bad wires.That fuse box in the trunk has seen it's share of problems. I would carefully disassemble the box looking for corrosion and chaffed wires. Switch the fuel pump relay with the horn relay if possible. Disconnect the battery before doing any of this work. Best case scenario would be to find and obvious poor connection. Where the wires leaving this box enter the interior of the car has been a trouble spot for damaged wires.
1 - 5 of 5 Posts
Chevrolet Malibu Forums
Chevy Malibu Forum is the best place for owners of the sedan to connect with the community and discuss MPG, mods, and more. Join now!
Full Forum Listing
Top Contributors this Month
View All
campb292
94 Replies
repairman54
45 Replies
Malibu Classic
17 Replies
Recommended Communities
