Chevrolet Malibu Forums banner
1 - 2 of 2 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
I have 2016 Malibu LT installing aftermarket amps for front rear sub and LC7I LOC.
I'VE hard the factory amp is already low level signal?
What wires on 16 pin plug at amp do I need to get the full range signal for loc?
Wired it different ways and mass same out come the sub amp would go into protect cause of such low signal coming outta Lc7i.
.5 v to 1.3 with volume at 90% playing 40hz test tone.. And Lc7i is maxed out on knobs
Is this to low of signal.

· Administrator
2011 Malibu LTZ 3.6L V6 Red Jewel Tintcoat
21,135 Posts
All Data DIY dot com will have factory manuals for your car. Those will be essential to keeping you from frying something when modifying your car.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.