Hey thanks for the reply, the wiper fuse was blown but I tested every fuse in that panel and they were all good. I also tested about half of the fuses under the hood but I didn't think the issue was under there. Do you know if the BCM went out would the hazard lights still work?
No turn signals
Hey guys, I recently got my 2011 Malibu back from the shop as my power steering motor went out. The next day it rained and I noticed the wipers didn't work, then the next day the turn signals quit working on my way home. I found a blown fuse for the wipers so thats fine but still no turn signals. The brake lights work, the hazard lights work and I can turn the headlights on and off with the turn signal switch so I don't think it's that. From what I've read it might be the BCM but I also read that can only be programmed by a dealer. Does anyone have any ideas about this? I feel like this car has been in the shop every three months since I had it, I even replaced the entire engine a few years ago cause the timing chain broke.
1 - 3 of 5 Posts
just to be clear, I did replace the wiper fuse too and that is working at least.Hey thanks for the reply, the wiper fuse was blown but I tested every fuse in that panel and they were all good. I also tested about half of the fuses under the hood but I didn't think the issue was under there. Do you know if the BCM went out would the hazard lights still work?
1 - 3 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevrolet Malibu Forums
Chevy Malibu Forum is the best place for owners of the sedan to connect with the community and discuss MPG, mods, and more. Join now!
Full Forum Listing
Top Contributors this Month
View All
campb292
88 Replies
repairman54
48 Replies
Drunken Elvis
17 Replies
Recommended Communities
