[Erik1109]

Even though the driving in the malibu LT2 feels pretty decent, I'm working on fabricating a strut bar for both the front and rear, i might make a DIY for it, for those with some fab/welding skills, but will most likely post pictures on here once completed.

 

[Silver LTZ]

I'd like to have a front tower brace for sure. They make them for the G6, but from what I read it won't fit.

 

[Erik1109]

Well, the rear one was easy to mock up, but with front its a bit more difficult with not much hood clearance... I'm trying to find a good diameter bar to use that works for front and rear, and doesn't rub with full throttle, not that we get much engine movement thanks to the lovely elec. throttle....

 

[ChevyFreak]

Once you get them made post up and you should def start selling them for a cheap price I would love to have these and also some better sway bars and lowering springs.

 

[Erik1109]

Our sway bars arent that bad, about an inch thick, but could always be beefier. malibus may stand to see improvement from arm bars or tie bars. I went with a manually adjustable coil set-up, and i keep it a little higher in the rear for a more aggressive stance.

 

[Silver LTZ]

Our sway bars arent that bad, about an inch thick, but could always be beefier. malibus may stand to see improvement from arm bars or tie bars. I went with a manually adjustable coil set-up, and i keep it a little higher in the rear for a more aggressive stance.

Who makes a coil-over set up for new Malibus? Please post some pics of your car.

 

[Erik1109]

I produced my own coilover set-up for my g-6 and malibu... I have to get a CF card reader to upload pictures, which i plan on doing soon.

Fabricating your own coilovers is not too complicated, the fronts took a bit of work with the tie-rods, but with the right set of skills anything is possible...