[Nam]

Thank you for helping. I was reading that thread. I will buy some dielectric gel and try it. I have unplugged it and plugged back without any changes.
Some more information that may help, is that the vehicle runs normally. However, left and right turn signals don't work and has no relay clicking sound.
My vehicle is 2007, 3.5L, 6 cylinder.

The BCM model is 15941000.

 

[Nam]

I took the BCM out and carefully putting all silicone dielectric grease on terminals of all plugs, on the back and the front. I did the same on the BCM side. I don't know if I put enough, but there is no change.
One thing I would like to add is that turn signal works, it's just the clicking noise is not there.

 

[Nam]

Relay could be shot...yes even if brand new. Put test leads of volt meter to before the relay....see if power is getting to the relay itself

I checked the relays on the BCM and they all worked. However, I didn't check with a light, only for continuity. I checked for both open and close.

 

[Nam]

I was refering to the flasher relay....i think its on the fuse panel....its round. Also remember there whats called normally open...and normally closed relays. So you need to know which one is which when testing relays. Some are zupposed to open ...or closed untill a certain voltage is applied

I will double check all relays in the fuse box under the hood. Is there another place? Other than under the hood and the passenger front center (BCM location) and the driver side trunk, is there another place?

I also saw 2 electrical wires just laying around in front of the BCM. Each have a fuse attached to it. I wonder what that is. It's easily shorted because it's just laying there.

 

[Nam]

Today, I replaced the BCM with a used one. The vehicle starts and moves. However, all the lights are still showing up on the dash and none of the meters work (mileage, speedometer, gas level, temperature, etc.).
So I put the old one back in, since I got a "Locked" on the info center, and I can't check mileage remained (for knowing when to fill gas).

I think there is either fuse or wiring issue somewhere.

 

[Nam]

Update ---

Thank you all for helping. My life was packed with work and I had to cover up the car. Last week, I bought a used gauge cluster and replaced it. That fixed the problem. The mileage was correct without any adjustment. Just pop in and out. I think I didn't have the battery connected when doing it, but not 100% sure.